Pontiac Grand Prix 2004-2008 Bolt on Vertical Doors Inc kit lambo doors USA

This system is everything you need for a successful, reliable and cost effective conversion in a minimum amount of time. The Kit includes Front Driver and Passenger Side Direct Bolt-on Lambo Door Hinges. 2 X Heavy Duty German made Gas shocks (Pressurized for your specific automobile) Hardware Kit (Nuts and Bolts) Detailed Installation Instruction.

The kit Features: Heavy duty constructions Easy installation Fully reversible. Heavy Duty German made shocks (Beware of other sellers using low quality shocks) Direct bolt on construction Made by Vertical Doors, Inc. With a Vertical Doors, Inc. Kit, your ride will keep its factory look and feel while you are driving but the moment you stop and raised your doors you will experience a whole new level of attention that no other upgrade can give you.

Kits are proudly made and patented in the United States and are bolt-on kits made specifically for your particular vehicle. They only manufacture the best kits, best quality, strongest kits, and most affordable kit for the quality. Our line-up includes all the major vehicle manufactures. Not only are our kit easy to install but they are also easy to operate, basically open your door like normal until it stops, at a predetermined position and then just raised your door up until it stops. You also have the option of not raising the door since unlike most Lambo Doors, Scissor Doors, Wing Doors, Butterfly Doors, Lamborghini Doors, etc, imitators; our Vertical Doors, Inc. Kits will allow you to get in and out without having to raise your doors. US MADE AND PATENTED Vertical Doors Inc. (unless otherwise stated in the body of the listing). Direct "Bolt On" hinge kit / Mounts to Factory Bolt Pattern /.

HERE ARE A COUPLE OF TECH TIPS. Do not take Door off during installation Please follow the detailed instruction manual step by step.

Use 2 painters tape to mark the factory location of your door on the horizontal and vertical plane also measure the distance between the apron and the front edge of the door by the bottom and top hinge. Make sure the mounting surface is flat as possible, if anything is there, grind the surface so the vertical door kit can sit and mount flat.

Make sure both allen screw adjustment on each system are adjusted accordingly. The kit requires no modification, the kit is a bolt on, but most inner fenders must be rolled or trimmed.